Print

SUPPLIED SWITCHPACK INFO

SUPPLIED SWITCHPACK INFO

SUPPLIED SWITCHPACK INFO

All Parasource lightbars EXCEPT EASY WIRE are supplied with a digital switchpack free of charge.

The same switchpack is supplied for all sizes and all specs of lightbar.Therefore you might find you have more switches than you need if you have purchased a lower spec bar.this is so options can be fitted by the user at any time by just pluging them in ..all wiring is already there...so its easy plug and play...

Approx size is 12x6x1cm.

The unit comes pre wired and pre programmed.

A plastic flat mounting bracket is supplied featuring a hiden magnet to hold the switchpack to it.This can be attatched by the supplied sticky pad or by using countersunk screws.

The switchpack has a realtime display of the standard and optional light patterns that are active at any given time.

10 buttons control 14 different functions including any options fitted at a later date by the customer.

 

BOTTOM RIGHT TOGGLE SWITCH POSITION 1=FLASH MAIN LIGHTS

BOTTOM RIGHT TOGGLE SWITCH POSITION 2=FLASH MAIN LIGHTS AND REAR REDS OR TRAFFIC DIRECTOR

BOTTOM LEFT TOGGLE SWITCH POSITION 1=FLASH SPOTS

BOTTOM LEFT TOGGLE SWITCH POSITION 2=STEADY ON SPOTS

TOP RIGHT TOGGLE SWITCH POSITION 1=RIGHT ALLEY FLASH

TOP RIGHT TOGGLE SWITCH POSITION 2=RIGHT ALLEY STEADY ON 

TOP LEFT TOGGLE SWITCH POSITION 1=LEFT ALLEY FLASH

TOP LEFT TOGGLE SWITCH POSITION 2=LEFT ALLEY STEADY ON

CENTRE RIGHT SOFT TOUCH SWITCH =CHANGE MAIN FLASHING LIGHTS PATTERN UP

CENTRE LEFT SOFT TOUCH SWITCH =CHANGE MAIN FLASHING LIGHTS PATTERN DOWN 

BOTTOM LEFT SOFT TOUCH SWITCH =TRAFFIC DIRECTOR OR REAR RED LEFT TO RIGHT

BOTTOM RIGHT SOFT TOUCH SWITCH =TRAFFIC DIRECTOR OR REAR RED RIGHT TO LEFT

TOP LEFT SOFT TOUCH SWITCH =TRAFFIC DIRECTOR OUT TO IN OR REAR RED SIMULTANIOUS FAST

TOP RIGHT SOFT TOUCH SWITCH =TRAFFIC DIRECTOR IN TO OUT OR REAR RED SIMULTANIOUS SLOW

(to activate traffic director or rear reds without main flashing lights, ie; ambers or blues.....turn bottom right toggle switch to position 2 and press centre soft touch main flashing lights pattern change switch until main mbers or blues turn off.)

The switchpack/lightbar is designed to be wired to a permanent live so as to keep its memory for the pattern selection last chosen.

If the power is interupted.. ie;  a problem with the vehicles electrical system,it will power all the leds the next time its turned on so the operator can check that the power outage hasnt damaged the lightbar.

The system is 12 volt negative earth and has reverse polarity protection.

THE UNIT CANNOT CONTROL ANY OTHER LIGHTS OTHER THAN OUR LIGHTBARS,AND OUR LIGHTBARS CAN ONLY BE CONTROLLED BY THIS SWITCHPACK.